​Installation steps of Water Purifier

There are many types of Water Purifiers, such as water softeners, direct drinking machines, pure water machines, and so on. Different Water Purifier installation methods are not the same, but the installation of Water Purifiers generally has to go through several similar steps. Next, the installation steps of the Water Purifier will be introduced in detail. Here are some answers.

Here is the content list:

Install Water Purifier accessories

Install Water Purifier host

Connect the water inlet tee

Connect water inlet, water outlet, sewage outlet

Flushing and debugging

Install Water Purifier accessories

Before installation, check whether the accessories are complete, and check whether all the pipelines, joints, faucets, and other water fittings of the Water Purifier are complete. Unpack the products that need to be assembled on-site and assemble them. Some Water Purifiers need to install special faucets, such as Water Purifiers and direct drinking machines. Some Water Purifier and softener are not required. The water purification faucet is mostly a gooseneck faucet, which is generally installed on the conditioning table of the kitchen and needs to be installed with holes.

Install Water Purifier host

When installing the water purifier, insert the unpacked RO membrane with two black "O" rings into the RO membrane tube until it feels inserted to the end, and then tighten the RO membrane tube end cap. Then remove the RO membrane pipe inlet PE pipe and place it in a container, turn on the water source and turn on the power of the Water Purifier, fill the first three pre-treatment filter housings with water, and let the black pre-filtered water flow out. After the black water has run out, turn off the power of the Water Purifier, and then install the removed RO membrane pipe into the water PE pipe.

Connect the water inlet tee

After the Water Purifier host is installed, connect the water inlet tee next. Turn off the main tap water switch, wrap the threaded inlet of the ball valve with raw material tape several times, and then directly connect the PE pipe to the side hole of the water inlet tee, and connect the PE pipe to the outlet of the ball valve.

Connect water inlet, water outlet, sewage outlet

Measure the distance and cut out the PE pipe, connect the water inlet tee to the PE pipe and then connect to the water inlet of the Water Purifier. Connect the PE pipe to the water inlet of the host, and the water inlet of the integrated machine and box-type water purifier is located on the outside of the machine. Connect the PE pipe to the post-activated carbon, here is the water outlet. When connecting the sewage outlet, the connection pipe is here, and it can be opened once a month for 10 minutes at a time.

Flushing and debugging

Then turn on the Water Purifier switch and let the water in for 20 minutes to rinse. Some black water will wash out. This is normal. This is a small amount of activated carbon powder. Don't drink the water for the first time or two. Put in the water a few times, and the water quality will be more stable. You can drink it straight away.

For more Water Purifier related questions, please consult HOMASTER. Our official website is https://www.homaster.com/.